Stanton DJLab.3 Manuel d'utilisateur

S TAN T O N MAG N E T IC S , IN C+1 954- 689-8833w w w . s t a n t o n d j . c o [email protected]'S MANUAL

Stanton Magnetics, Inc. – Warranty Provision – Returns for Repairs or Replacement WARRANTY Through Stanton’s authorized dealers around the World, Sta

STANTON WARRANTY REGISTRATION CARDPERSONAL INFOPRODUCT INFONameAddressCity State ZipCountryTelephoneModel

PLACESTAMPHEREStanton Magnetics, Inc.3000 SW 42nd StreetHollywood, FL 33312U.S.A.

IMPORTANT TO SAFETY 1. Read these Instructions 2. Keep these Instructions 3. Heed all Warnings 4. Follow all Instructions 5. Do not use this

LINE VOLTAGE SELECTION 115V230V 1) The desired voltage of your turntable may be set with the VOLTAGE SELECTOR switch on the rear panel of the main

M.202 CONTENTS 1) Input fader - Controls individual source levels/volume (channels) in the mix. 2) Input toggle switch - Selects which source w

QUICK SETUP DIAGRAM Study this setup diagram. Make sure all faders are at "zero" and all devices are off. First, connect all input sources.

SPECIFICATIONS M.202 INPUT / OUTPUT IMPEDANCE & SENSITIVITY: LINE -14dB/10K OHM ±2dB PHONO -50dB /47K OHM ±2dB MIC -60dB /2.2K OHM ±2dB

CONNECTIONS 1) Connect the power cord to an AC outlet. 2) Connect the RCA cable to the PHONO input of your mixer. You can also use a line input by s

T.80 TURNTABLE CONTENTS 1) Start/Stop 2) Strobe Dots 3) Slipmat 4) Center Spindle 5) Motor ON/OFF Switch 6) Platter Revolution Speeds (RPM) 7) Tar

SPECIFICATIONS T.80 POWER SOURCE AC 100V, 50/60Hz (For Japan) AC 110V, 60Hz (For Taiwan) AC 120V, 60Hz (For U.S.A.,Canada,Mexico)